| Applying Wall Stickers (Type A) |
 |
Step1. Choose where you desired placement. Start with a smooth clean and dry surface. |
 |
Step 2. Plan where you put the part of sticker. Simply peel off from backing paper. |
 |
Step 3. Take out the image from the backing paper. Rub it with soft cloth or palstic card. |
|
|
|
 |
Step 1. Take the transfer film out. Put transfer film on top of graphic sticker. |
 |
Step 2. Rub top transfer film with soft sloth or towel. |
 |
Step 3. Cut out images. |
 |
Step 4. Peel off transfer film from paper sheet and attach to clean dry surface. |
 |
Step 1. Place and tape the installation sheet on the wall. |
 |
Step 5. Rub transfer film carefully. so, Air bubble don't occur. |
 |
Step 2. Mark for the place of movement. |
 |
Step 6. Peel off transfer film carefully from the graphic sticker. |
 |
Step 3.Peel-off the installation sheet's number. |
|
 |
Step 4. Remove numbers and dots from board and peel off the cover. |
|
 |
Step 5. Place numbers or dots on it's designated place. |
Each decal is made up of 3 Layers :
The top layer is transfer tape just like masking tape.
The middle layer is your vinyl decal.
The bottom layer is the paper backing.
|
 |
Step 6. Remove the installation sheet. |
Step 1. Clean the area you are going to apply the sticker to throughly (note: Do not use windex or any other ammonia type cleaner, soap and warm water will do fine)
Step 2. Measure and mark your location first before removing the paper backing from the sticker.
Step 3. Peal away the paper backing of the sticker making sure that all of the sticker peices stayed attached to the application tape.
Step 4. Place the adhesive side down against the chosen surface and using a credit card or something similar, rub the surface thoroughly working any bubbles toward the edge.
Step 5. After a couple of minutes you can remove the application tape by pulling it straight back, be sure that the graphic has stayed on the surface and not the tape.
Step 6. If you see any bubbles you can use a small sewing pin or thumb tack to poke a tiny hole and then push the bubble out of the graphic with your finger. |
 |
Step 7. Insert the battery. |
 |
Step 8. Place the movement and set the time. |
|
|
) 
